BMW Recalls 720,796 US Cars Again After Water Pump Fix Falls Short

BMW has issued a repeat US recall over water pump connector fire risks. Australia's original campaign covered 13,588 cars, with no revised recall announced.

BMW Recalls 720,796 US Cars Again After Water Pump Fix Falls Short
4 min read

BMW has recalled 720,796 vehicles in the United States for a second time after its 2024 water pump connector repair failed to fully address a potential fire risk.

US owners are advised to park affected vehicles outside and away from structures until the new repair is completed, including cars that have already received the earlier fix.

Car finance or novated leasing could save you thousands

Get a free, no-obligation quote from our finance partner, Loan Options — for straightforward car finance, or package this car through your salary with a novated lease.

The repeat recall, originally reported by Carscoops, covers selected BMW models from 2012 to 2018. Australia's original campaign covered 13,588 vehicles, but BMW Australia has not said whether the new US recall will extend here.

The US National Highway Traffic Safety Administration (NHTSA) received the new recall, numbered 26V-733, on 4 November 2026. An improperly sealed electrical connector on the water pump can allow water in, causing a short circuit and increasing the risk of fire.

The replacement remedy remains under development. US owner notification letters are expected to be mailed in December 2026, with affected VINs searchable on NHTSA.gov from 25 December.

The campaign replaces recall 24V-608, filed in August 2024 for the same number of vehicles. That repair involved an inspection, replacement of the water pump and plug connector where needed, and a protective shield, at no cost.

Carscoops reported that BMW investigated connector overheating in vehicles that had already received the repair, including a US incident in June 2025. BMW initially suspected incorrect repairs, but further cases continued into 2026.

The investigation included a CT scan of the connector in April 2026 and assistance from an outside expert. Between May and September, BMW concluded that water ingress could make the connectors brittle over time, potentially leading to overheating, a short circuit and, in rare cases, fire.

Carscoops reported that BMW estimates fewer than 0.1 per cent of recalled vehicles have the problem, and knew of 10 US field incidents as of 28 October 2026.

Affected US vehicles include older BMW 3 Series models, specifically the 2012-2016 328i and 328i xDrive, alongside the 2 Series, 4 Series, 5 Series, X1, X3, X4, X5 and Z4 models listed below.

US modelModel years
228i and 228i xDrive2014–2016
328i and 328i xDrive2012–2016
428i and 428i xDrive2014–2016
528i and 528i xDrive2012–2016
X12012–2015
X32013–2017
X42015–2018
X5, including X5 xDrive40e plug-in hybrid2013–2018
Z42012–2016

What Australian BMW owners need to know

Australia's original recall, REC-006063, was published on 30 August 2024 under BMW campaign number 0011800700. It covered 13,588 BMW 328i, 520i, 528i, X1, X3 and Z4 vehicles from 2011 to 2018.

The Australian defect notice identified a manufacturing fault that could allow liquid into the electrical water pump connectors, causing a short circuit and potentially a vehicle fire. Owners were instructed to contact an authorised BMW dealer for a free plug connector inspection and replacement if necessary.

As of 17 November 2026, no new Australian recall notice covering the revised remedy had been published on the Australian Government's vehicle recalls website. The park-outside instruction applies to vehicles covered by the US campaign.

Australian owners can check their VIN at vehiclerecalls.gov.au or contact BMW Australia's recall hotline on 1800 243 675.

Got a car to sell or trade in?

Get competing offers from dealers with CarSauce Sell. Free, no obligation.

Get my offers

Frequently Asked Questions